DJI Phantom 2 Pre-Flight Checklist

1. Check battery status of smart flight battery, RC controller, FPV Display and GoPro
2. Check GoPro for memory card and remove camera lens cap
3. Check the 5.8 GHz antennas are tight and pointed in the correct direction
4. Check that the antenna of RC controller being perpendicular to ground and pointing upwards
5. Check that Switch 1 and 2 set to proper location, away from Pilot 
6. Initialize the equipment in the following sequential order
1. RC Controller
2. Black Pearl  FPV Display and 5.8 GHz Receiver
3. GoPro Power, Record Format and Record Power
4. DJI Phantom 2 Smart Battery
7. If flying in deferent location: Calibrate Compass of DJI Phantom 2
1. Move S1 switch with full though 5 times, Phantom 2 indication is steady yellow light on rear LEDs
2. Rotate horizontally, Phantom 2 indication is steady green light on rear LEDs
3. Rotate vertically front down, Phantom 2 indication is normal flashing green light on rear LEDs
8. Check the GPS status of Phantom 2, flashing green light of rear LEDs
9. Start Propeller
10. DJI Phantom 2 is ready to take-off